3/8/2024 0 Comments Roof rafter cross ties![]() ![]() ![]() When you have the right measurement, nail them into place using three 10d nails on both ends. Use a level before installing them permanently. The ends must be placed against the rafters which should have a ½ inch from the rafter’s edges. Use three nails for 2×4 chords, two on one side and one on the other, and four nails for 2×6 chords, two on each side. Make sure to toenail on both sides of the truss on each end. It should be precisely cut to fit the two rafters making sure that it matches the roof angle. As with rafter installation, use an 8d nail, making sure that about 2/3 of the nail length ends up in the wall plate. Step 5 – Cut the Rafter TiesĬut out the rafter ties according to your measurement and the angle that your project requires. Step 4 – Install the Other RaftersĪdd more rafters as your project requires making sure that the ridge is evenly installed and then rafters are measured properly. To nail this in place, use the type of nail or screw that the manufacturers require. The lower end of the rafter must be nailed to the wall plate using a couple of 16d nails and then attach the joint that has a metal anchor. If you are using 2 x 4, use two end nails. Place another rafter onto the layout mark and then nail it into place using the same size of the nail. Place one rafter to the side of the ridge board and then nail it in place using three 16d. Then, have your assistant to nail the ridge board on the support. When you have already set the rafters on the ends of the two walls, hold the end part of the ridge board and use a level to make sure that it is evenly installed. Step 2 – Tack the Rafters into the Wall End Support Then, nail them in place to the farthest end of the ridge board to be temporary support. First, you need to place a couple of rafters into the top of the wall. When installing the rafters, you will need two assistants. Step 1 – Install the Two Rafters as Temporary Supports on the Wall
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |